Table of Contents
Advertisement
6C-12 ENGINE FUEL
DISASSEMBLY AND REASSEMBLY
"A" : Apply oil
1. Fuel filter assembly (including check valve)
2. Grommet
3. Tube
4. Housing
5. O-ring
6. Fuel level sensor (Fuel sender gauge)
7. Fuel pump
8. Cushion
9. Bracket
Disassemble and reassemble fuel pump assembly, noting the fol-
lowings.
CAUTION:
• While removing fuel level gauge, do not contact resis-
tor plate (1) or deform arm (2). It may cause fuel level
gauge to fail.
• When removing grommet from fuel tube or bracket sub
assembly, be very careful not to cause damage to
grommet installed section (sealed section in bore).
Should it be damaged, replace it with new one, or fuel
will leak from that part.
• When removing fuel level sensor (3), press snap-fit part (4)
and slide it in the arrow direction as shown in figure.
• When installing fuel level sensor to housing, fit fuel level sen-
sor securely.
10. Fuel pressure regulator
11. Gasket
12. Fuel pump plate
Do not reuse.
Advertisement
Table of Contents
