Direct Clutch Piston Lip And Direct Clutch Balancer Lip - Suzuki Ignis Service Manual

7B-102 AUTOMATIC TRANSMISSION (4 A/T)

Direct Clutch Piston Lip and Direct Clutch Balancer Lip

Check each lip for wear, deformation, cut, and/or hardening. If
necessary, replace.
ASSEMBLY
1) Install new D-ring (5) to direct clutch No.1 drum (6).
Apply grease to D-ring and fit it to drum.
"A": Grease 99000-25030
2) Install piston (4) into direct clutch No.1 drum.
Use care that the piston lip does not get twisted or caught.
Apply grease to the lip of the piston.
"A": Grease 99000-25030
3) Install direct clutch return spring seat (3) and direct clutch
balancer (2).
1. Snap ring
4) Install new shaft snap ring (1).
Compress return springs and install shaft snap ring in groove
by using a flat end rod or the like (3).
Place special tool (clutch spring compressor) on spring seat
and compress springs with a press (2).
CAUTION:
Do not compress return spring more than necessary.
Special tool
(A) : 09926-96010
5) Install discs, plates and flange (1) in following order.
(1) Flange No.1 → (2) Disc → (3) Plate → (4) Disc → (5)
Flange No.2
NOTE:
Before assembly, new discs should be soaked in auto-
matic transmission fluid for at least 2 hours.