System Check Flow Table - Suzuki Ignis Service Manual

SYSTEM CHECK FLOW TABLE

Step
1 1) Record details of the problem (failure, complaint) and how it
occurred as described by the customer.
For this purpose, use of such a questionnaire from as shown
below will facilitate collecting information to the point required for
proper analysis and diagnosis.
2) Check if what the customer claimed in "CUSTOMER QUES-
TIONNAIRE" is actually found in the vehicle and if that symptom
is found, whether it is identified as a failure.
(This step should be shared with the customer if possible.)
3) Check malfunction indicator lamp ("EPS" warning lamp) opera-
tion referring to "MALFUNCTION INDICATOR LAMP ("EPS"
LIGHT) CHECK".
4) Check DTC referring to "DTC CHECK" in this section and record
the DTC(s).
5) Clear DTC if any malfunction DTC exists referring to "DTC
CLEARANCE" in this section, then recheck DTC.
Is any malfunction DTC detected?
2 1) Inspect and repair referring to applicable "DTC TABLE" in this
section.
2) Clear DTC referring to "DTC CLEARANCE" in this section.
Does the trouble recur?
3 1) Test drive the vehicle and turn steering wheel fully to the right
and left during test driving. See WARNING. Check if any trouble
exists.
2) Inspect and repair basic parts referring to "DIAGNOSIS CHART"
in SECTION 3.
3) If the trouble cannot be repaired in Step 3-2), inspect and repair
referring to "TROUBLE DIAGNOSIS (FOR TROUBLE NOT INDI-
CATED BY ON-BOARD DIAGNOSTIC SYSTEM)" in this sec-
tion.
Does the trouble recur?
4 1) Confirm that the problem symptom has gone and P/S system is
free from any abnormal conditions. If what has been repaired is
related to the malfunction DTC, clear the DTC once and perform
test driving as in Step 3-1) and confirm that no DTC is indicated.
Is any malfunction DTC detected?
5 1) Check DTC referring to "DTC CHECK" in this section.
Is any malfunction DTC detected?
WARNING:
Carry out test in very little traffic area to prevent an accident.
Action
ELECTRICAL POWER STEERING (P/S) SYSTEM 3B1-5
Yes
Go to Step 2.
Go to Step 5.
Go to Step 5.
Go to Step 5.
Go to Step 2.
No
Go to Step 3.
Go to Step 4.
Go to Step 4.
END
Go to Step 3.