Advanced Functions; High--Speed Cycle Cutting (G05) - Siemens Sinumerik 802D sl Programming Manual

04.07
4.6

Advanced functions

4.6.1 High- -speed cycle cutting (G05)
The G05 command is used to call any subprogram simular to a M98 P_ subpro-
gram call. The subprogram to be called can be a pre--compiled partprogram
deriving from Siemens code.
Format
G05 Pxxxxx Lxxx ;
Pxxxxx program number to be called
Lxxx number of repetitions
(L1 applies when this parameter is omitted)
Example
G05 P10123 L3 ;
This block calls program 10123.mpf and executes it 3 times.
Limitations
S Only Siemens code part programs can be pre--compiled.
S When calling a subprogram by G05, it is not switched into Siemens mode.
The G05 command behaves like a M98 P_ subprogram call.
S A block containing a G05 command without address P is ignored without alarm.
S A block containing a G05.1 command with or without address P as well as G05
P0 or G05 P01 is ignored without alarm.
© SIEMENS AG 2007 All rights reserved
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning -- 04.07 Edition
Enhanced Level Commands
4.6 Advanced functions
4-147