Siemens Sinumerik 802D sl Programming Manual page 121

04.07
Symbols and figures
The individual canned cycle are explained in the following sections. The following
symbols are used in the figures below:
Fig. 4-33
Caution
!
In each canned cycle, the address R (distance between initial level and point R) is
always treated as a radius.
However, Z or X (distance between point R and hole bottom) is treated either as a
diameter or radius, depending on the specification.
Face deep hole drilling cycle (G83) / side deep hole drilling cycle (G87)
The setting of GUD7, _ZSFI[20] decides whether The deep hole drilling cycle or
high-speed deep hole drilling cycle is applied. The normal drilling cycle is applied
whenever depth of cut for each drilling is not specified.
© SIEMENS AG 2007 All rights reserved
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning -- 04.07 Edition
Positioning (rapid traverse G00)
Cutting feed (linear interpolation G01)
Manual feed
Dwell time
P1
M code for C-axis clamp
Mα
M code for C-axis unclamp
M (α+I)
Enhanced Level Commands
4.1 Program support functions (1)
4-121