Siemens Sinumerik 802D sl Programming Manual page 124

Enhanced Level Commands
4.1 Program support functions (1)
Mα:
M(α+1):
P1:
P2:
d:
Example
M3 S2500 ;
G00 X100.0 C0.0 ;
G83 Z--35.0 R--5.0 Q5000 F5.0 ;
C90.0 ;
C180.0 ;
C270.0 ;
G80 M05 ;
Drilling cycle (G83 or G87)
The normal drilling cycle is applied whenever the depth of cut for each drilling is not
specified. In this case, the tool is retracted from the bottom of the hole in rapid tra-
verse.
Format
G83 X(U)... C(H)... Z(W)... R... P... F... M... K... ;
or
G87 Z(W)... C(H)... X(U)... R... P... F... M... K... ;
X, C or Z, C: Hole position
Z or X: The distance from point R to the bottom of the hole
R_: Distance from the initial level to R level
P_: Dwell time at bottom of hole
F_: Cutting feedrate
K_: Number of repetitions (if required)
M_: M code for clamping C-axis (if required)
4-124
M code for clamping C-axis
M code for unclamping C-axis
Dwell time (program)
Dwell time specified in GUD7, _ZSFR[22]
Retraction amount specified in GUD7, _ZSFR[21]
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning -- 04.07 Edition
Rotate the drilling tool
Positioning of X and C axis
Maching hole 1
Maching hole 2
Maching hole 3
Maching hole 4
Cycle cancel and drilling tool stop
© SIEMENS AG 2007 All rights reserved
04.07