Nc Stop; Operating Mode Change - Siemens SINUMERIK 828D Function Manual

2.13.3

NC stop

Non-modal and modal synchronized actions (ID)
Traversing motions from non-modal and modal synchronized actions are stopped by NC
stop.
A non-modal or modal synchronized action also remains active while the channel is in the
"interrupted" state:
DB21, ... DBX35.6 == 1 (channel state "interrupted")
If the condition is fulfilled during this time, the actions are executed except for traversing
motions.
Stopped traversing motions are continued with NC start.
Static synchronized actions (IDS)
Traversing motions from static synchronized actions are not stopped by NC stop.
2.13.4

Operating mode change

Status after operating mode change:
From:
Synchronized action
Traversing motion
Speed-controlled
spindle
Master value
coupling
Measuring
1) The synchronized actions become active again after changing back to the AUTOMATIC mode.
2) End of program is delayed until the axis is at standstill.
M30
Synchronized actions
Function Manual, 07/2012, 6FC5397-5BP40-3BA0
Modal and non-modal synchronized action (ID)
Aborted or inactive
Aborted
MD20110 $MC_RESET_MODE_MASK, bit 13 = <value>
1 ⇒ The coupling remains active
0 ⇒ The coupling is released
Aborted
2.13 Control behavior in specific operating states
1)
2)
Active
Detailed description
Static synchronized action (IDS)
Active
Active
Active
Active
Active
131