Processing Mode (Icycon, Icycof) - Siemens SINUMERIK 828D Function Manual

2.8.2

Processing mode (ICYCON, ICYCOF)

Function
The
within technology cycles.
Per default, the processing mode
Processing mode: ICYCON
A non-modal technology cycle is executed in the
all actions programmed in a block is initiated in the same interpolation cycle. As soon as all
initiated actions are completed, the next block is processed in the following interpolation
cycle.
A distinction is made between single-cycle and multi-cycle actions. Examples are:
● Single-cycle actions: Auxiliary function output, value assignments
● Multi-cycle actions: Traversing motions of axes and spindles
Each block of a technology cycle requires at least one interpolation cycle.
Processing mode: ICYCOF
All actions of all blocks of a technology cycle are initiated in parallel in the
mode.
Subprogram as part program
If a subprogram is executed as a part program, the
effect.
Syntax
In the action part of a synchronized action
ID=1 <condition part> DO [ICYCOF] <technology cycle 1> [ICYCOF |
ICYCON] <technology cycle 2> ...
As a property of a subprogram
PROC <name> [ICYCOF | ICYCON]
Within a subprogram
PROC <name>
N10 ...
N20 [ICYCOF | ICYCON]
N90 ...
N100 [ICYCOF | ICYCON]
N110 ...
RET
Synchronized actions
Function Manual, 07/2012, 6FC5397-5BP40-3BA0
and commands can be used to control the processing mode of the actions
ICYCOF ICYCON
is active.
ICYCON
processing mode. The execution of
ICYCON
ICYCOF
Detailed description
2.8 Technology cycles
ICYCOF
and commands have no
ICYCON
processing
121