Keychain Commands; Keychain; Direction; Table 73 Keychain Command - Nokia 7302 Basics, Management And Oam Manual

"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
(2 of 2)
4.4.3
4.4.3.1
Table 73
4.4.3.2
Table 74
Issue: 10
Item Description
Parameters old-entry-id — Enter the entry number of an existing entry.
Values: 1 — 1536
new-entry-id — Enter the new entry-number to be assigned to the old entry.
Values: 1 — 1536

Keychain Commands

keychain

keychain command
Item Description
Syntax [no] keychain keychain-name
Context configure>system>security
Description This command enables the context to configure keychain parameters. A keychain must be
configured on the system before it can be applied to a session.
The no form of the command removes the keychain nodal context and everything under it from
the configuration. If the keychain to be removed is in use when the no keychain command is
entered, the command will not be accepted and an error indicating that the keychain is in use
will be printed.
Default None
Parameters keychain-name — Specifies a keychain name which identifies this particular keychain entry.
Values: An ASCII string up to 32 characters.

direction

direction command
Item Description
Syntax direction
Context configure>system>security>keychain
Description This command specifies the data type that indicates the TCP stream direction to apply the
keychain.
Default None
3HH-11982-AAAA-TQZZA
Security
69