Ethernet Connection Fault Management
8.12.2.5
Table 225
8.12.3
8.12.3.1
Table 226
(1 of 2)
194
single-ended-loss-test
single-ended-loss-test command
Item
Description
Syntax
single-ended-loss-test mac-address mep mep-id domain md-index association ma-index
[priority priority] [interval {1s}] [send-count send-count]
Context
oam>eth-cfm
Description
This command specifies to initiate a loss measurement test between the specified
mac-address and the specified mep-id MEP.
Parameters
The parameters with their values and defaults are as follows:
•
mac-address — Specifies a unicast destination MAC address.
Values: xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx, where xx is a hexadecimal number.
•
mep mep-id — Specifies the local mep-id.
Values: 1 — 8191
•
md-index — Specifies the index of the MD to which the MEP is associated, or 0, if none.
Values: 1 to 4294967295
•
ma-index — Specifies the index to which the MEP is associated, or 0, if none.
Values: 1 to 4294967295
•
send-count — Specifies the number of LMM messages to send, expressed as a decimal
integer
Values: 2 to 5
Default: 2
•
interval {1s} — Specifies the interval between groups of consecutive LMM packets (for
example, if send-count is 5 and interval is 1s, then 5 LMM packets are sent at 1-s intervals)
Values: 1s
Default: 1s
•
priority — Specifies the priority
Values: 0 to 7
Default: 7
Show Commands
association
association command
Item
Description
Syntax
association [ma-index] [detail]
Context
show>eth-cfm
Description
This command displays eth-cfm association information.
3HH-11982-AAAA-TQZZA
"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
Issue: 10