Flow Of Configuration Until Operation Is Started; Flow Of Configuration Until Operation Is Started; Basic Usage; Application Usage - Panasonic GP-X Series User Manual

1.8 Flow of Configuration Until Operation Is Started

1.8.1 Basic Usage

Turn the power on.
Select the material of the
object to be detected.
Adjust linearity.
Determine the reference
point for detection.
Select the measuring mode
and enter conditions.
Adjust the display scale.
Adjust the analog voltage
output scale.
Enter the upper and lower
limit values.
Set the judgment output.
Start detection.

1.8.2 Application Usage

Use the mutual interference
prevention function.
Use the memory switching
function for the settings.
Use the RS-232C
communication function to
configure and perform data
communication.

1.8.3 Usage with Optional Unit

Use BCD output.
Calculate measurements
between two controllers.
22
Refer to section "4.1 Selection of the Object to
Be Detected" on page 70.
Refer to section "4.2 Three-Point Calibration
(Linearity adjustment)" on page 71.
Zero Setting" on page 28.
Refer to "
Refer to section "3.4 Setting According to
Application (Application mode)" on page 52.
Refer to section "4.4 Display Scale" on page 76.
Refer to section "4.5 Analog Voltage Output
Scale" on page 81.
Refer to section "3.2 Upper and Lower Limit
Value Settings" on page 48.
Refer to section "4.3 Judgment Output Setting"
on page 73.
Refer to section "4.7 Interference
Prevention Setting" on page 90.
Refer to section "4.8 Memory Switching Method
Setting" on page 93.
Refer to section "5.1 RS-232C Communication
Setting" on page 98.
Refer to section "5.2 Settings Related to BCD
Output Unit (Optional)" on page 100.
Refer to section "5.3 Settings Related to
Controller Communication Unit (Optional)"
on page 103.