1.7.2 Mounting the Option Unit
Perform mounting after turning the power off. If mounting is performed with the
power turned on, failure may result. As well, keep away from mounting brack-
ets when the power is on.
Mounting of controller communication unit and BCD output unit
1. Peel off the side seal of the controller.
2. Mount the controller and the mounting frame on the panel in the orienta-
tion shown in the figure below.
For details, refer to section "1.6.1
Mounting the Controller" on
page 16.
3. Mount the controller communication unit or BCD output unit from the
side.
4. Mount the mounting bracket from the side.
If the fitting inter-
feres with another
unit or the like and it
cannot be mounted
sideways,
from the rear while
opening its arms.
20
mount
1 to 2.5mm
(Mounting from rear)