Panasonic 2WAY Multi Technical & Service Manual page 160

14) Tube connection confi rmation (Level 2) <Cannot be set if not W MULTI>
Rejection conditions
Setting start operation method
Setting change operation method : Automatic completion. Press the SET (S005) key for one second when
15) Heating automatic address setting (Level 2)
Rejection conditions
Setting start operation method
Setting change operation method : Automatic completion. Press the SET (S007) key for one second when
Automatic address setting status is successively displayed as shown below.
The meaning of the numbers is as follows.
0: Automatic address start setup
1: Indoor unit automatic address setup wait
2: Engine operation in progress
3: Indoor unit checking in progress
4: Address setting in progress
5: Setting complete
16) Cooling automatic address setting (Level 2)
Rejection conditions
Setting start operation method
Setting change operation method : Automatic completion. Press the SET (S007) key for one second when
Automatic address setting status is successively displayed as shown below.
The meaning of the numbers is as follows.
0: Automatic address start setup
1: Indoor unit automatic address setup wait
2: Engine operation in progress
3: Indoor unit checking in progress
4: Address setting in progress
5: Setting complete
: Indoor unit operation in progress, cooling automatic addressing in
progress
: Push the SET (S005) key for 1 second.
(Forced / error LED light)
turning off.
(Forced / error LED off)
: Not accepted during indoor operation
: Press the SET (S007) key for one second.
(TEST/WARNING LED light)
turning off.
(TEST/WARNING LED off)






: Not accepted during indoor operation
: Press the SET (S007) key for one second.
(TEST/WARNING LED light)
turning off.
(TEST/WARNING LED off)






V–41