Transceiver - Kenwood WD-K10 Series User Manual

2 PREPARATION
2.4 Setting Various Functions
Notification Tones During the Use of Transceiver
Depending on the selected mode and status, you can hear the notification tones of the transceiver from earphones.
The following table shows the name and content of various notification tones.
Name
Alert tone
Key Operation tone
Out of Range Tone
Battery Warning
(10-second interval)
Battery Warning Alert tone
(5-second interval)
Error
Listening Talk switch tone
Listening Talk migration tone
Volume Change tone
Maximum volume notification tone
Minimum volume notification tone
All Call tone
Mode Select
Key Lock tone
Key Lock off tone
Settings saved complete tone
External Control tone
Complete
Hold start notification tone
Hold end notification tone
Notification tones are set to On by default but you can set them to Off using the system setup. For details on the settings,
please consult the authorized dealer or installer.
Invalid key operation. When the operation mode of the transceiver did not
change. Already in the mode.
When a key is pressed.
The [PTT] key is pressed when the user moves to a location with weak radio
signals or when there are no empty channels in the base station.
When the battery remaining capacity of the transceiver is low. Please charge
the battery promptly.
When there is an abnormality in the battery.
When a sub unit in Listening Mode has switched to a transmission mode.
When a sub unit in Listening Mode has switched to a call transmission mode.
When the volume has changed
When you try to increase the volume when it is already at its maximum.
When you try to decrease the volume when it is already at its minimum.
When All Call starts.
When the Call mode is switched in Group Select and All Call.
When the unit returns to Group Call from All Call or broadcast status.
When Key Lock is executed.
When Key Lock is canceled.
When contents configured in Setup menu mode have been saved.
When External Control is started.
When All Call or Broadcast is completed.
When the Talk Setting is "PTT-Lock" and the [PTT] key is pressed and call
transmission has started.
When the Talk Setting is "PTT-Lock" and the [PTT] key is pressed and call
transmission has ended.
Status
Contents
46