Table of Contents
Advertisement
Chapter 9. Diagnostics
10 hex, Input Channel Open Wire
The GBC generates this error when the Genius Analog module detects an open wire condition on an
input channel.
Correction
Correct the problem causing the condition.
20 hex/32 decimal, Wiring Error
The GBC generates this error when the Genius Analog module detects an improper RTD connection
or thermocouple reverse junction fault.
Correction
Correct the problem causing the condition.
40 hex/64 decimal, Internal Fault
The GBC generates this error when the Genius Analog module reports a cold junction sensor fault on
a thermocouple block or an internal error in an RTD block.
Correction
Correct the problem causing the condition.
80 hex/128 decimal, Input Channel Shorted
The GBC generates this error when it detects an input channel shorted on a Genius RTD or Strain
Gauge Block.
Correction
Correct the problem causing the condition.
81 hex/129 decimal, Invalid Data
The GBC generates this error when it detects invalid data from a Genius Analog input block.
Correction
Correct the problem causing the condition.
GENA Fault
The GENA Fault has no fault descriptions associated with it. GENA Fault Byte 2 is the first byte of the
fault extra data.
80 hex/128 decimal
The Genius I/O operating software generates this error when it detects a failure in a GENA block
attached to the Genius I/O bus.
Correction
Replace the GENA block.
432
PACSystems* RX7i, RX3i and RSTi-EP CPU Programmer's Reference Manual
GFK-2950C
Advertisement
Table of Contents
