Status; Operation:enable; Operation[:Event] - HP E1351A User Manual

Fet multiplexer
Table of Contents

Advertisement

STATus

Subsystem Syntax

:OPERation:ENABle

Parameters
Comments
Example

:OPERation[:EVENt]?

Comments
Example
70
HP E1351A/53A 16-Channel FET Multiplexer Command Reference
The
subsystem reports the bit values of the Operation Status
STATus
Register. This enables the Status Register to set a bit after a bit is set to 1 by
the Operation Status Register.
STATus
:OPERation
number
:ENABle <
[:EVENt]?
STATus:OPERation:ENABle <
Register to set a bit in the Status Register. For multiplexer modules, when
bit 8 in the Operation Status Register is set to 1, bit 7 in the Status Register
is set to 1.
Parameter Name
Parameter Type
number
Setting Bit 7 of the Status Register:
256
sets bit 7 of the Status Register to 1 after bit 8 of the Operation
Status Register is set to 1.
Disabling STATus:OPERation: The
disables the
STATus:OPERation:ENABle
Related Commands:
STATus:PRESet
Enable the Status Register Bit 7
STAT:OPER:ENAB 256
STATus:OPERation[:EVENt]?
Status Register (only bit 8 is used by the multiplexer modules).
Setting Bit 8 of the Operation Status Register: Bit 8 (Scan
Complete) is set to 1 after a scanning cycle completes. Bit 8 returns
to 0 after sending the
correct operation set to 0 by
Returned Data after sending the
Command: The command returns +256 if bit 8 of the Operation
Status Register is set to 1. The command returns +0 if bit 8 of the
Operation Status Register is set to 0.
Related Commands:
Reading the Operation Status Register after a Scanning Cycle
STAT:OPER?
read and print the register value
>
number
>
enables the Operation Status
Numeric
STATus:OPERation:ENABle
STATus:PRESet
command.
,
[ROUTe:]SCAN
*SRE
Enables bit 7 of the Status Register.
returns the bit value of the Operation
STATus:OPERation[:EVENt]?
before scanning.
*CLS
STATus:OPERation[:EVENt]?
,
[ROUTe:]SCAN
*SRE
Reads the register value
+256 shows bit 8 is set to 1; +0
shows bit 8 is set to 0.
Range of Values
1 - 32768
command
,
,
,
*STB?
*SPOLL
command. For
,
,
*STB?
*SPOLL
Chapter 5

Advertisement

Table of Contents
loading

This manual is also suitable for:

E1353a

Table of Contents