Setting The Card Id Switch - HP E1351A User Manual

Setting the Card ID Switch

Chapter 2
The multiplexer module can be an HP E1351A, HP E1352A or HP E1353A
depending on which terminal module is installed. With a normal
connection, the terminal module will automatically configure the module
for the appropriate model. To identify a module without a terminal module,
set the Card ID switch as shown in Figure 2-6. The ID numbers are:
Model
HP E1351A
HP E1352A
HP E1353A
For normal connections, leave the switch at the factory setting which is all
pins open.
Figure 2-6. Card ID Switch
Configuring the HP E1351A/53A FET Multiplexer Modules
Value Configuration
0 all pins open
8 pin 3 closed
2 pin 1 closed
21