Adding Signal Conditioning Components/Current Shunts - HP E1351A User Manual

Adding Signal Conditioning Components/Current Shunts

Chapter 2
The multiplexer module's terminal module allows you to add components
on each channel for the following:
Low-Pass Filters
–
Attenuators
–
Current Shunts (for current measurements using a voltmeter)
–
Figure 2-8 shows how to install the appropriate components for the above
configurations. In the figure, channel 12 shows a low pass filter
configuration, channel 07 an attenuator configuration, and channel 04 a
current shunt configuration.
Figure 2-8. Signal Conditioning Components/Current Shunts
Configuring the HP E1351A/53A FET Multiplexer Modules 23