Mitsubishi Electric M800 Series Manual page 430

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
(PR) #1261 set33
bit1: Operation panel I/O emergency stop function OFF
Select whether to disable the emergency stop function when an operation panel I/O unit is disconnected.
(This setting is enabled for separated-type NC only)
0: Enable the emergency stop function
1: Disable the emergency stop function
* While the operation panel I/O unit is connected to the NC unit, the emergency stop function is enabled ir-
respective of this parameter.
bit2: Synchronized turning ON/OFF of NC and display
Select whether to synchronize the turning ON/OFF of the M800W Series NC controller and display.
0: NC and display turn ON/OFF independently.
1: NC and display turn ON/OFF in synchronization with each other.
* If no operation panel I/O unit is connected, the NC and display turn ON/OFF independently, irrespective of
this parameter.
bit3: PLC high-speed process start timing selection
Select the type of PLC high-speed process start timing.
0: Type 1 (default)
1: Type 2
bit4: High-speed ladder execution cycle
Specify the high-speed ladder execution cycle. (Standard value: 0)
0: Default
1: Twice the default (equivalent to Mitsubishi M700V Series)
(Note) When the parameter (#1261 set33/bit4) is set to its default value, the high-speed ladder execution
cycle differs according to the model and the number of part systems.
bit5: Operation switch at OT and soft limit in synchronous operation method
This parameter switches the axis operation at OT and soft limit for slave axis in the synchronous operation
method.
When independent operation method or correction mode is set, the operation will be the same as #1261=0
(disable).
0: When OT signal is turned ON for only slave axis according to OT and soft limit, the slave axis stops but
master axis does not stop.
1: When one of master axis or slave axis is in the OT and soft limit, both master and slave axes stop.
(PR) #1262 set34
bit2: Disable warning for coordinate system selection without 3D manual feed spec.
[M8]
Select whether to display a warning when hypothetical coordinate system has been selected although 3D
manual feed is not included in the specifications.
0: Display
1: Not display
[C80]
Not used.
bit3: Condition of turning OFF Tool life end signal (for L system only)
[M8]
Select when to turn OFF the tool life end signal in the tool life management 1 for L system.
0: When M function finish signal (FIN) is turned ON
1: When a tool that has not reached the end of life is selected
413 IB-1501279-H