M800/M80/E80/C80 Series Alarm/Parameter Manual
12 Program Errors (P)
P72
No spec: Herical cutting
Details
A helical command has been issued though it is out of specifications.
Remedy
Check whether the specifications are provided for the helical cutting.
An Axis 3 command has been issued by the circular interpolation command. If there is no helical specifi-
cation, move the linear axis to the next block.
P73
No spec: Spiral cutting
Details
A spiral command was issued though it is out of specifications.
Remedy
Issue the G02.1 and G03.1 commands for circular interpolation.
Check whether the specifications are provided for the spiral cutting.
P74
Can't calculate 3DIM arc
Details
The 3-dimension circular cannot be obtained because the end block was not specified during 3-dimension cir-
cular interpolation supplementary modal.
The 3-dimension circular cannot be obtained due to an interruption during 3-dimension circular interpolation
supplementary modal.
Remedy
Correct the program.
P75
3DIM arc illegal
Details
An illegal G code was issued during 3-dimension circular interpolation modal.
Otherwise, 3-dimension circular interpolation command was issued during a modal for which a 3-dimension cir-
cular interpolation command cannot be issued.
Remedy
Correct the program.
P76
No spec: 3DIM arc interpolat
Details
G02.4/G03.4 was commanded though there is no 3-dimension circular interpolation specification.
Remedy
Check the specifications.
P90
No spec: Thread cutting
Details
A thread cutting command was issued though it is out of specifications.
Remedy
Check the specifications.
P93
Illegal pitch vaule
Details
An illegal thread lead (thread pitch) was specified at the thread cutting command.
Remedy
Correct the thread lead for the thread cutting command.
P100
No spec: Cylindric interpolat
Details
A cylindrical interpolation command was issued though it is out of specifications.
Remedy
Check the specifications.
IB-1501279-H
128