1-8. Checks on Completion of Installation
S754 (D-15) : Group ID setting switch for LAN
Sets the network group ID.
This switch is used to set the PERIPH terminal.
Refer to System Setup Manual for details.
S755 (E-15) : Unit ID setting switch for LAN
Sets the unit ID within a network.
This switch is used to set the PERIPH terminal.
Refer to System Setup Manual for details.
<Connectors>
CN752 (F-15) : TERMINAL pin
This pin is connected to the main CPU control terminal
and used during maintenance.
Used only for production in the assembly factory.
CN802 (J-15) : ISP common connector
Used only for production in the assembly factory. Used for
program writing into the JTAG device with ISP.
CN803 (K-15) : JTAG2
Used only for production in the assembly factory.
<TEST terminals>
E751 (C-15) : GND pin
Used as GND when measuring of the each check
terminals.
TP755 (C-15) : + + + + + 12 V check terminal
+12 V measuring terminal.
<LEDs on the CPU DK module> (G-5)
DI1 (green) (B-5) : CD (Card Detect) status LED
Lit when the CPU-DK module is inserted correctly to the
parent board.
DI2 (green) (F-3) : RUN status LED
Lit when the CPU-DK module starts operating.
DI3 (F-3) (green) : STATUS4 status LED
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
DI4 (green) (B-5) : + + + + + 3.3 V
Indicates the status of the VCC (CORE) and VCC (I/O)
power supplied to the CPU-DK module.
Lit while the specified powers are turned on.
1-18
DI6 (F-3) (green) : STATUS3 status LED
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
DI7 (F-3) (green) : STATUS2 status LED
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
DI8 (F-4) (green) : STATUS1 status LED
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
<Switches on the CPU-DK module> (G-5)
SW1 (E-5) : RESET switch
Pressing this switch resets the CPU-DK module.
n
In some machines in which the CPU-DK module is
installed, the system reset may be activated.
SW2 (C-5) : MODE switch
8-pin DIP switch
Used only for production in the assembly factory.
All switches are set to OFF for normal operation.
Default setting when shipped from the factory is all OFF.
DCU-8000 IM