Hitachi Compute Blade 500 Series User Manual page 48

In SMP configuration, a type of server blade is added to the server blade
number as follows.
Initialize
Initialize status.
2-30
Example for the primary server blade
Slot: 6 (primary)
Example for a non-primary server blade
Slot: 4 (non primary)
Shows a state of initialization for server blades. When initialization has
been successfully completed, operation such as power supplies is
available.
• Not install : Server blade is not installed.
• Not initialize : Server blade is not initialized.
• Init executing : Server blade is being initialized.
• Init comp : Server blade is successfully initialized.
• Reinitializing : Server blade is being reinitialized after completely
initialized, such as BMC restart and server blade firmware update.
• Init comp NG : Server blade was not successfully initialized.
• ----- : This indicates the larger slot number (an odd number) used
for the full-width blade.
In an SMP configuration, if you specify the primary server blade, the
entire SMP configuration is displayed.
Each of the following indicates an initialization status of the entire
SMP configuration:
• Not install : No server blade in SMP configuration is installed.
• Not initialize : One or more server blades in SMP configuration are
installed but BMC initialization has not started.
• Init executing : BMC on a server blade in SMP configuration is in
initialization.
• Init comp : BMC on all server blades in SMP configuration has
been successfully initialized.
• Reinitializing : BMC on a server blade in SMP configuration is in re-
initialization after completely initialized.
• Init comp NG : A server blade in SMP configuration was not
successfully initialized. This can occur after initialization is
executed when server blades or the SMP connection board
required for SMP configuration are not all installed.
• ----- : This indicates the larger slot number (an odd number) used
for the full-width blade.
In an SMP configuration, if you specify a non-primary server blade,
the initialization status of a single server blade is displayed.
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide