Hitachi Compute Blade 500 Series User Manual page 221

disable : Not cooperate with power supply
-a2 <power_ac_recovery>
The setting of power supply cooperation
enable : Cooperate with power supply
disable : Not cooperate with power supply
-a3 <power_ac_recovery>
The setting of power supply cooperation
enable : Cooperate with power supply
disable : Not cooperate with power supply
-F
Executes the command without inquiry.
Show items
None
Message
None
Example
[Sets the redundancy type of power supply module to N+N.]
$ set power ps-module -r n+n
Confirm? (y/[n]):y
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
[Disable Power supply module optimization.]
$ set power ps-module -o disable
Confirm? (y/[n]):y
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
[Disable the setting of power supply cooperation of power module 0.]
$ set power ps-module -a0 disable
Confirm? (y/[n]):y
I0001 : Setting was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
Hitachi Compute Blade 500 Series CLI Console User's Guide
CLI command
2-203