Turning The Phone On - Sony CM-B1200 Operating Instructions Manual

Turning the phone on

To use your phone, the power must be turned on.
It is preferable to extend the antenna, since this
maximizes signal strength and minimizes
interference.
Extending the antenna
Hold the end of the antenna and pull up until
fully extended.
To retract the antenna
Push the antenna down until it is fully
retracted.
Turning the power on
Hold down
PWR
starts searching for a signal.
When the phone has found a service signal, the standby display appears.
Now the phone is ready to use.
To check the signal strength
The signal strength icon indicates various levels of signal strength. It is
best to make calls when the signal is strong, although calls can be made
when the signal strength is weak.
Strong
If you are out of the service area
The out-of-service icon ( ) appears, and the phone
searches for a service signal.
If a signal cannot be found, the phone enters
power save mode. It will "wake up" automatically
at intervals (based on carrier network settings) to
search for a service signal.
Turning the power off
Hold down
PWR
following display appears briefly, then the phone
turns off.
18
B2200 10-20draft3
for about one second. A beep sounds and the phone
for about one second. The
18
Pull up
SEND END
PWR
CLR PWR
Weak
Looking for
service.....
:Saved #s
:Features
POWERING OFF
8/21/98, 12:12 PM