Turning The Phone On - Sony CM-S1100 Operating Instructions Manual

Turning the phone on

To use your phone, the power must be turned on. It is preferable
to extend the antenna, since this maximizes signal strength and
minimizes interference.
Extending the antenna
Hold the end of the antenna and pull up until fully extended.
To retract the antenna
Push the antenna down until it is fully retracted.
Turning the power on
Hold down
PWR
phone starts searching for a signal.
When the phone has found a service signal, the standby display
appears. Now the phone is ready to use.
To check the signal strength
The signal strength icon indicates various levels of signal strength. It is best to make calls
when the signal is strong, although calls can be made when the signal strength is weak.
If you are out of the service area
The out-of-service icon ( ) appears, and the phone searches for a
service signal.
If a signal cannot be found, the phone enters power save mode.
It will "wake up" automatically at intervals (based on carrier
network settings) to search for a service signal.
Turning the power off
Hold down
PWR
appears briefly, then the phone turns off.
16
for about one second. A beep sounds and the
Strong
for about one second. The following display
Pull up
SEND
PWR
CLR
Looking for
service.....
:Saved #s
:Features
My Phone
12:34P 12/25
:Saved #s
:Features
Weak
Looking for
service.....
:Saved #s
:Features
v
No Service
available.
Now in power
saving mode.
POWERING OFF
END
PWR