Canon DP-V2411 Instruction Manual page 77

Sub Menu
Display Name
Power Indicator/Button LED Settings
Power Indicator
Brightness
Display Button LED
Button Name Lighting
Time (sec.)
Fan Settings
Fan Control
5
Fan Stop
Compatible Settings
HDMI
Protect Settings
Password
Protect Target
Picture Mode
Select Channel
Function Settings
Protect
Sets the name of the main unit. You can input up to 16 alphanumeric characters.
Off Adjusts the brightness of the power indicator on the main unit. The greater
1 to 5 (3) the number, the higher the brightness.
On, Off Sets the F buttons and the lamp on the face.
60, 30, 10, 5 Sets the time (sec) until the lamp on the face goes out, if no operation is
performed.
Sets the operation of internal fan.
On, Off
Fan noise can be eliminated when the main unit is used during shooting or
when silent operation is needed.
Set this in advance to stop the fan either manually or by linking it with the
camera during photography (
changes so that the fan can be stopped.
On, Off If [Fan Stop] is set to [On] and when [Fan Control] is set to [On], the
fan can be stopped. At room temperature (25 °C), the fan remains off
for approximately one minute (Max of about 6 minutes when using DC
power). The fan operates at a faster speed than usual before and after the
fan is stopped to lower the internal temperature.
Sets the connection compatibility with HDMI equipment.
Normal [Normal]: All formats are supported.
Compatible 1 [Compatible 1]: Set this option when video is not played correctly in
Compatible 2
[Compatible 2]: Set this option when video is not played correctly in
Locks the settings so they cannot be changed. When you press the MENU button, [Signal/System
Information] appears, but other operations are grayed out because they are locked.
Set a password to protect settings. Use a four-digit number (0000 to
9999). The initial password is blank.
You can remove Picture Mode and Select Channel from the items to be
protected.
On, Off [On]: Protects the [Picture Mode] settings.
[Off]: Removes the [Picture Mode] settings from protect target.
On, Off [On]: Protects the [Select Channel] settings.
[Off]: Removes the [Select Channel] settings from protect target.
On, Off
[On]: Protects the [Function Settings] settings.
[Off]: Removes the [Function Settings] settings from protect target.
Select [OK] to protect. When a password has been set, enter the
password and select [OK].
 Unlocking Protect Settings
Move the selection frame to [Protect] and press the Jog dial for
approximately 3 seconds. When a password has been set, enter the
password and select [OK].
Setting Options (Bold: factory default)
71). When this is set to [On], the mode
[Normal]. HDR signals of a luminance higher than that of the display
main unit are not supported.
[Normal] or [Compatible 1]. [4K50.00P/60.00P] and HDR signals are
not supported.
OSD Menu
77