Panasonic KX-NS1000 Programming Manual page 821

Feature Guide References
2.1.1.3 Direct Inward Dialling (DID)/Direct Dialling In (DDI)
DDI / DID Destination—Day, Lunch, Break, Night
Specifies the DDI/DID destination in each time mode.
Value Range
Max. 5 digits (consisting of 0–9)
Maintenance Console Location
18.3 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table
PC Programming Manual References
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main
18.3.1 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table—Automatic Registration
Feature Guide References
2.1.1.3 Direct Inward Dialling (DID)/Direct Dialling In (DDI)
4.3.1 TIE Line Service
Tenant Number
Specifies the tenant number, to determine the Time Table by which calls are distributed depending on the time
of day.
Value Range
1–32 or 1–128
Note
The maximum number of tenants depends on the System Capacity Selection setting made when the
Easy Setup Wizard was run for the PBX. If the System Resource Type was selected, the maximum
number of tenants is 128. If the Standard Type or IP-Extension Type was selected, the maximum number
of tenants is 32. For details, refer to "5.4.1 Easy Setup Wizard" in the Installation Manual.
Maintenance Console Location
18.3 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table
PC Programming Manual References
10.4 PBX Configuration—[2-4] System—Week Table
Feature Guide References
2.1.1.3 Direct Inward Dialling (DID)/Direct Dialling In (DDI)
18.3 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table
PC Programming Manual 821