Commissioning The Mbts By Using Local Maintenance Terminal And M2000 - Huawei 3900 Series Commissioning Manual

3900 Series Multi-Mode Base Station
Commissioning Guide
7
Commissioning the MBTS by Using Local
About This Chapter
This chapter describes how to use local maintenance terminal at the MBTS to upgrade MBTS
software and configure MBTS data, check MBTS hardware status, rectify MBTS hardware faults
(if any) to facilitate the establishment of MBTS OM channels. This chapter also describes how
to check the operating status of the MBTS on the M2000.
7.1 Procedure for Commissioning the MBTS Using Local Maintenance Terminal and M2000
At the local end of the MBTS, you can use local maintenance terminal to upgrade MBTS software
and configure MBTS data and to facilitate the establishment of MBTS OM at the MBTS. You
can also check whether the MBTS hardware status is normal according to the board status and
LED status, to locate and rectify faults (if any) in time. At the M2000, you can check the MBTS
operating status.
7.2 Running the GBTS SMT
To run the GBTS site maintenance terminal (SMT), you need to first set the IP address of the
SMT client, connect the base station and the SMT, and then log in to the SMT.
7.3 Configuring the Basic Data of the GBTS
This section describes how to configure the basic data of the GBTS such as the GBTS boards
and logical objects. You must configure the basic data of the GBTS before performing the local
commissioning on the GBTS side.
7.4 Checking the Transmission Between the BBU and the BSC on the BTS Side
This section describes how to check the status of the LEDs on the panels of the GTMU and
UTRP (if the UTRP is installed) and how to check the connections of the E1 cable and E1 surge
protection transfer cable to ensure that the BBU properly communicates with the BSC.
7.5 Running the NodeB LMT
To run the NodeB LMT, you need to first set the IP address of the LMT client, connect the base
station and the LMT, and then log in to the LMT.
Issue 02 (2010-07-30)
Maintenance Terminal and M2000
NOTE
The GBTS local maintenance terminal is named SMT, the NodeB local maintenance terminal is named
NodeB LMT, and the eNodeB local maintenance terminal is named eNodeB LMT. Select a local
maintenance terminal according to the mode of the base station to be commissioned.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Commissioning the MBTS by Using Local Maintenance
Terminal and M2000
7-1