Sony IPELA PCS-G50 Operating Instructions Manual page 145

To connect to a computer via a hub
Connect the Communication Terminal to a computer using the UTP straight
cable.
Computer
to LAN connector
To configure the Communication Terminal
Open the "Device Setup" on page 1 of the General Setup menu, and then enter
the IP address of the computer where the NetMeeting application is installed
in the "T.120 PC Address" text box. (See page 57.)
Set "T.120 Data" to "On" on the Communication Setup menu. (See page 51.)
Note
We recommend that you set "Audio Mode" to "G.728" on the Communication Setup
menu.
To connect to a remote party using NetMeeting
Before connecting, install the NetMeeting application in your computer.
1
Double-click the NetMeeting icon, or click "NetMeeting" from the Start
menu on the computer's window.
NetMeeting starts.
2
Set the Communication Terminal to communication mode.
Check that the "T.120" indicator is displayed on the monitor screen.
3
Click "Calling" in the NetMeeting window on the computer of either a
local or remote party.
4
Enter the IP address set for the Communication Terminal in the "Address"
text box of the "Call to" dialog box.
Conducting a Data Conference Using NetMeeting – T.120 Data Conference
Hub
to 100BASE-TX/
10BASE-T
UTP straight cable (not supplied)
TERMINAL VISCA OUT
AUDIO OUT AUDIO IN VIDEO IN
(MIXED) AUX LINE CAMERA AUX IN
MIC
(PLUG IN POWER)
1 2
100BASE-TX/
DC 19.5V 1 2 WHITE
IR OUT BOARD 10BASE-T
AUX CONTROL EC-MIC RGB OUT
1 2 CTRL-S 1 2
AUX MONITOR
VIDEO OUT
DSB
ISDN UNIT
145