HP 12500 Series Configuration Manual page 45
Mpls, routing switch series
Hide thumbs
Also See for 12500 Series:
- Configuration manual (338 pages) ,
- Network management and monitoring command reference (320 pages) ,
- Command reference manual (157 pages)
Table of Contents
Advertisement
# After the configurations, two local LDP sessions are established, one between Switch A and
Switch B and the other between Switch B and Switch C. Execute the display mpls ldp session
command on each switch to view the LDP session information, and execute the display mpls ldp
peer command to view the LDP peer information. Take Switch A as an example:
[SwitchA] display mpls ldp session
Total number of sessions: 1
----------------------------------------------------------------
Peer-ID
----------------------------------------------------------------
2.2.2.9:0
----------------------------------------------------------------
LAM : Label Advertisement Mode
[SwitchA] display mpls ldp peer
LDP Peer Information in Public network
Total number of peers: 1
-----------------------------------------------------------------
Peer-ID
----------------------------------------------------------------
2.2.2.9:0
----------------------------------------------------------------
Allow all static routes and IGP routes to trigger LDP to establish LSPs.
4.
# Configure the LSP establishment triggering policy on Switch A.
[SwitchA] mpls
[SwitchA-mpls] lsp-trigger all
[SwitchA-mpls] return
# Configure the LSP establishment triggering policy on Switch B.
[SwitchB] mpls
[SwitchB-mpls] lsp-trigger all
[SwitchB-mpls] quit
# Configure the LSP establishment triggering policy on Switch C.
[SwitchC] mpls
[SwitchC-mpls] lsp-trigger all
[SwitchC-mpls] quit
Verify the configuration.
5.
# Execute the display mpls ldp lsp command on each switch to view the LDP LSP information. Take
Switch A as an example:
<SwitchA> display mpls ldp lsp
-------------------------------------------------------------------
SN
DestAddress/Mask
------------------------------------------------------------------
1
1.1.1.9/32
2
2.2.2.9/32
3
3.3.3.9/32
4
11.1.1.0/24
5
20.1.1.0/24
LDP Session(s) in Public Network
Status
LAM
Operational
DU
Transport-Address
2.2.2.9
LDP LSP Information
In/OutLabel
3/NULL
NULL/3
NULL/1024
3/NULL
NULL/3
37
SsnRole
FT
MD5
Passive
Off
Off
FT
: Fault Tolerance
Discovery-Source
Vlan-interface2
Next-Hop
In/Out-Interface
127.0.0.1
-------/InLoop0
10.1.1.2
-------/Vlan2
10.1.1.2
-------/Vlan2
0.0.0.0
-------/Vlan4
10.1.1.2
-------/Vlan2
KA-Sent/Rcv
5/5
Advertisement
Table of Contents
Troubleshooting
