HP 12500 Series Configuration Manual page 353

To do...
Return to system view
Enter interface view
Enable RIPng on the interface
NOTE:
For more information about RIPng, see
Configuring OSPFv3 between PE and CE
An OSPFv3 process belongs to the public network or a single VPN instance. If you create an OSPF
process without binding it to a VPN instance, the process belongs to the public network.
To configure OSPFv3 between PE and CE:
To do...
Enter system view
Create an OSPFv3 process for a
VPN instance and enter the
OSPFv3 view
Set the router ID
Return to system view
Enter interface view
Enable OSPFv3 on the interface
NOTE:
• Deleting a VPN instance will delete all related OSPFv3 processes at the same time.
For more information about OSPFv3, see
•
Configuring IPv6 IS-IS between PE and CE
An IPv6 IS-IS process belongs to the public network or a single VPN instance. If you create an IPv6 IS-IS
process without binding it to a VPN instance, the process belongs to the public network.
To configure IPv6 IS-IS between PE and CE:
To do...
Enter system view
Use the command...
quit
interface interface-type
interface-number
ripng process-id enable
Layer 3—IP Routing Configuration Guide
Use the command...
system-view
ospfv3 [ process-id ] vpn-instance
vpn-instance-name
router-id router-id
quit
interface interface-type
interface-number
ospfv3 process-id area area-id
[ instance instance-id ]
Layer 3 IP Routing Configuration Guide
—
Use the command...
system-view
345
Remarks
—
—
Required
By default, RIPng is disabled on an
interface.
.
Remarks
—
Required
Perform this configuration on PEs.
On CEs, create a normal OSPF
process.
Required
—
—
Required
By default, OSPFv3 is disabled on
an interface.
Perform this configuration on PEs.
.
Remarks
—