HP 12500 Series Configuration Manual page 273

Figure 68 Network diagram
Device
Spoke-CE 1
Spoke-PE 1
Spoke-CE 2
Spoke-PE 2
Configuration procedure
Configure an IGP in the MPLS backbone to ensure IP connectivity between spoke-PE and hub-PE.
1.
# Configure Spoke-PE 1.
<Spoke-PE1> system-view
[Spoke-PE1] interface loopback 0
[Spoke-PE1-LoopBack0] ip address 1.1.1.9 32
[Spoke-PE1-LoopBack0] quit
[Spoke-PE1] interface vlan-interface 4
[Spoke-PE1-Vlan-interface4] ip address 172.1.1.1 24
[Spoke-PE1-Vlan-interface4] quit
[Spoke-PE1] ospf
[Spoke-PE1-ospf-1] area 0
[Spoke-PE1-ospf-1-area-0.0.0.0] network 172.1.1.0 0.0.0.255
[Spoke-PE1-ospf-1-area-0.0.0.0] network 1.1.1.9 0.0.0.0
[Spoke-PE1-ospf-1-area-0.0.0.0] quit
[Spoke-PE1-ospf-1] quit
# Configure Spoke-PE 2.
<Spoke-PE2> system-view
[Spoke-PE2] interface loopback 0
Interface IP address
Vlan-int2 10.1.1.1/24
Loop0 1.1.1.9/32
Vlan-int2 10.1.1.2/24
Vlan-int4 172.1.1.1/24
Vlan-int3 10.2.1.1/24
Loop0 3.3.3.9/32
Vlan-int3 10.2.1.2/24
Vlan-int5 172.2.1.1/24
Device
Hub-CE
Hub-PE
265
Interface IP address
Vlan-int6 10.3.1.1/24
Vlan-int7 10.4.1.1/24
Loop0 2.2.2.9/32
Vlan-int4 172.1.1.2/24
Vlan-int5 172.2.1.2/24
Vlan-int6 10.3.1.2/24
Vlan-int7 10.4.1.2/24