HP 12500 Series Configuration Manual page 119

------------------------------------------------------------------
LSP Information: RSVP LSP
------------------------------------------------------------------
FEC In/Out Label
3.3.3.3/32 1024/3
Perform the display mpls te tunnel command on each switch. You can see that two MPLS TE tunnels
are traversing Switch B and Switch C.
[SwitchA] display mpls te tunnel
LSP-Id Destination
1.1.1.1:1 4.4.4.4
[SwitchB] display mpls te tunnel
LSP-Id Destination
1.1.1.1:1 4.4.4.4
2.2.2.2:1 3.3.3.3
[SwitchC] display mpls te tunnel
LSP-Id Destination
1.1.1.1:1 4.4.4.4
2.2.2.2:1 3.3.3.3
[SwitchD] display mpls te tunnel
LSP-Id Destination
1.1.1.1:1 4.4.4.4
[SwitchE] display mpls te tunnel
LSP-Id Destination
2.2.2.2:1 3.3.3.3
Perform the display mpls lsp verbose command on Switch B. You can see that the bypass tunnel is
bound with the protected interface VLAN-interface 2 and is currently unused.
[SwitchB] display mpls lsp verbose
-------------------------------------------------------------------
LSP Information: RSVP LSP
-------------------------------------------------------------------
No
IngressLsrID
LocalLspID
Tunnel-Interface
Fec
Nexthop
In-Label
Out-Label
In-Interface
Out-Interface
LspIndex
Tunnel ID
LsrType
Bypass In Use
BypassTunnel
Mpls-Mtu
No
In/Out IF
Vlan4/Vlan5
In/Out-If
-/Vlan1
In/Out-If
Vlan1/Vlan2
-/Vlan4
In/Out-If
Vlan2/Vlan3
Vlan5/-
In/Out-If
Vlan3/-
In/Out-If
Vlan4/Vlan5
: 1
: 1.1.1.1
: 1
: Tunnel4
: 4.4.4.4/32
: 3.1.1.2
: 1024
: 1024
: Vlan-interface1
: Vlan-interface2
: 4097
: 0x22001
: Transit
: Not Used
: Tunnel Index[Tunnel5], InnerLabel[1024]
: 1500
: 2
111
Vrf Name
Name
Tunnel4
Name
Tunnel4
Tunnel5
Name
Tunnel4
Tunnel5
Name
Tunnel4
Name
Tunnel5