Import-Route (Rip View) - HP FlexNetwork 3600 v2 Series Command Reference Manual

undo host-route
View
RIP view
Default level
2: System level
Parameters
None
Description
Use host-route to enable host route reception.
Use undo host-route to disable host route reception.
By default, receiving host routes is enabled.
In some cases, a router may receive many host routes from the same network segment. These
routes are not helpful for routing and occupy a large amount of network resources. Use undo
host-route to disable receiving of host routes.
RIPv2 can be disabled from receiving host routes, but RIPv1 cannot.
Examples
# Disable RIP from receiving host routes.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] undo host-route

import-route (RIP view)

Syntax
import-route protocol [ process-id | all-processes | allow-ibgp ] [ cost cost | route-policy
route-policy-name | tag tag ] *
undo import-route protocol [ process-id | all-processes ]
View
RIP view
Default level
2: System level
Parameters
protocol: Specifies a routing protocol from which to redistribute routes. It can be bgp, direct, isis,
ospf, rip, or static.
process-id: Process ID, in the range of 1 to 65535. The default is 1. It is available only when the
protocol is isis, rip, or ospf.
all-processes: Enables route redistribution from all the processes of a protocol. This keyword takes
effect only when the protocol is rip, ospf, or isis.
allow-ibgp: When the protocol argument is set to bgp, allow-ibgp is an optional keyword.
cost: Cost for redistributed routes, in the range of 0 to 16. If cost is not specified, the default cost
specified by the default cost command applies.
tag: Tag marking redistributed routes, in the range of 0 to 65,535. The default is 0.
41