HP FlexNetwork 10500 Series Configuration Manual page 75

Figure 24 Network diagram
11::0/64
Requirements analysis
•
To ensure that the LSRs establish IPv6 LSPs automatically, enable IPv6 LDP on each LSR.
•
To establish IPv6 LDP LSPs, configure an IPv6 routing protocol to ensure IP connectivity
between the LSRs. This example uses OSPFv3.
•
To ensure that LDP establishes IPv6 LSPs only for the routes 11::0/64 and 21::0/64, configure
IPv6 LSP generation policies on each LSR.
•
To ensure that LDP establishes IPv6 LSPs only over the link Switch A—Switch B—Switch C,
configure IPv6 label advertisement policies as follows:
Switch A advertises only the label mapping for FEC 11::0/64 to Switch B.

Switch C advertises only the label mapping for FEC 21::0/64 to Switch B.

Switch D does not advertise label mapping for FEC 21::0/64 to Switch A. Switch D does not

advertise label mapping for FEC 11::0/64 to Switch C.
Configuration procedure
Before configuration, disable the spanning tree feature globally or map each VLAN to an MSTI. For
more information, see Layer 2—LAN Switching Configuration Guide.
1. Configure IPv6 addresses and masks for interfaces, including the loopback interfaces, as
shown in
2. Configure OSPFv3 on each switch to ensure IP connectivity between them. (Details not
shown.)
3. Enable MPLS and IPv6 LDP:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] mpls lsr-id 1.1.1.9
[SwitchA] mpls ldp
[SwitchA-ldp] quit
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] mpls enable
[SwitchA-Vlan-interface2] mpls ldp ipv6 enable
[SwitchA-Vlan-interface2] mpls ldp transport-address 10::1
[SwitchA-Vlan-interface2] quit
Loop0
1.1.1.9/32
100::1/128
Vlan-int2
10::1/64
Vlan-int4 Vlan-int6
11::1/64 30::1/64
Switch A
Figure 24. (Details not shown.)
Loop0
2.2.2.9/32
100::2/128
Vlan-int2 Vlan-int3
10::2/64 20::1/64
Switch B
Loop0
4.4.4.9/32
100::4/128
Vlan-int6 Vlan-int7
30::2/64 40::1/64
Switch D
66
Loop0
3.3.3.9/32
100::3/128
Vlan-int3
20::2/64
Vlan-int7
Vlan-int5
40::2/64
21::1/64
Switch C
21::0/64