Configuring Routing Between Pes; Configuring Bgp Vpnv4 Route Control - HP FlexNetwork 10500 Series Configuration Manual

Step
2. Enter BGP instance view.
3. Configure the PE as an
IBGP peer.
4. Create the BGP IPv4
unicast family and enter its
view.
5. Enable IPv4 unicast route
exchange with the
specified peer or peer
group.
6. (Optional.) Configure route
redistribution.

Configuring routing between PEs

Step
1. Enter system view.
2. Enter BGP instance view.
3. Configure the remote PE as
a BGP peer.
4. Specify the source interface
for route updates.
5. Create the BGP VPNv4
address family and enter its
view.
6. Enable BGP VPNv4 route
exchange with the specified
peer.

Configuring BGP VPNv4 route control

BGP VPNv4 route control is configured similarly with BGP route control, except that it is configured in
BGP VPNv4 address family view. For more information about BGP route control, see Layer 3—IP
Routing Configuration Guide.
To configure BGP VPNv4 route control:
Step
1. Enter system view.
Command
bgp as-number [ instance
instance-name ]
peer { group-name | ip-address
[ mask-length ] } as-number
as-number
address-family ipv4 [ unicast ]
peer { group-name | ip-address
[ mask-length ] } enable
import-route protocol
[ { process-id | all-processes }
[ allow-direct | med med-value
| route-policy
route-policy-name ] * ]
Command
system-view
bgp as-number [ instance
instance-name ]
peer { group-name | ip-address
[ mask-length ] } as-number
as-number
peer { group-name | ip-address
[ mask-length ] }
connect-interface interface-type
interface-number
address-family vpnv4
peer { group-name | ip-address
[ mask-length ] } enable
Command
system-view
209
Remarks
N/A
By default, no BGP peers exist.
By default, the BGP IPv4
unicast family is not created.
By default, BGP does not
exchange IPv4 unicast routes
with any peer.
A CE must redistribute its routes
to the PE so the PE can
advertise them to the peer CE.
Remarks
N/A
N/A
By default, no BGP peers exist.
By default, BGP uses the output
interface of the optimal route
destined for the peer as the
source interface.
By default, the BGP VPNv4
address family is not created.
By default, BGP does not
exchange BGP VPNv4 routes
with any peer.
Remarks
N/A