Configuring A Bgp Pw - HP FlexNetwork 10500 Series Configuration Manual

[PE2-xcg-vpn1-ldp] peer 192.2.2.2 pw-id 1000
[PE2-xcg-vpn1-ldp-192.2.2.2-1000] quit
[PE2-xcg-vpn1-ldp] quit
[PE2-xcg-vpn1] quit
6. Configure CE 2.
<CE2> system-view
[CE2] interface vlan-interface 10
[CE2-Vlan-interface10] ip address 100.1.1.2 24
[CE2-Vlan-interface10] quit
Verifying the configuration
# Verify that an LDP PW has been established on PE 1.
[PE1] display l2vpn pw
Flags: M - main, B - backup, BY - bypass, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1
1 up, 0 blocked, 0 down, 0 defect, 0 idle, 0 duplicate
Xconnect-group Name: vpn1
Peer
192.3.3.3
# Verify that an LDP PW has been established on PE 2.
[PE2] display l2vpn pw
Flags: M - main, B - backup, BY - bypass, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1
1 up, 0 blocked, 0 down, 0 defect, 0 idle, 0 duplicate
Xconnect-group Name: vpn1
Peer
192.2.2.2
# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)

Configuring a BGP PW

Network requirements
Create a BGP PW between PE 1 and PE 2 to allow communication between CE 1 and CE 2 within
VLAN 10.
Create Ethernet service instance 10 on GigabitEthernet 1/0/1 to match packets with an outer VLAN
ID of 10 on each PE.
PW ID/Rmt Site In/Out Label
1000 1151/1279
PW ID/Rmt Site In/Out Label
1000 1279/1151
Proto
LDP
Proto
LDP
347
Flag Link ID State
M 1 Up
Flag Link ID State
M 1 Up