Configuring An Ldp Pw; Configuring A Bgp Pw - HP FlexNetwork 10500 Series Configuration Manual

Step
4. Configure a static PW,
and enter VSI static PW
view.

Configuring an LDP PW

Before you configure an LDP PW, enable global and interface MPLS LDP on the PE. For information
about MPLS LDP configuration, see
To configure an LDP PW:
Step
1. Enter system view.
2. Enter VSI view.
3. Specify LDP signaling
for PWs, and enter
VSI LDP signaling
view.
4. Configure an LDP PW,
and enter VSI LDP
PW view.

Configuring a BGP PW

To configure a BGP PW, perform the following configurations on PEs:
•
Configure BGP to advertise VPLS label block information.
•
Create a BGP PW.
Command
peer ip-address [ pw-id pw-id ]
in-label label-value out-label
label-value [ no-split-horizon |
pw-class class-name |
tunnel-policy tunnel-policy-name ]
*
"Configuring LDP."
Command
system-view
vsi vsi-name
pwsignaling ldp
peer ip-address [ pw-id pw-id ]
[ no-split-horizon | pw-class
class-name | tunnel-policy
tunnel-policy-name ] *
379
Remarks
By default, no static PWs exist.
If both the default PW ID in the
default-pw-id command and a PW ID
in the peer command are configured,
the PW ID in the peer command is
used. If only the default PW ID is
configured, the default PW ID is used.
If no default PW ID is configured, you
must provide a PW ID in the peer
command.
You must specify the
no-split-horizon keyword to disable
split horizon when you configure an
NPE to establish a U-PW with a UPE.
Remarks
N/A
N/A
By default, no PW signaling protocol is
specified.
By default, no LDP PWs exist.
If both the default PW ID in the
default-pw-id command and a PW ID
in the peer command are configured,
the PW ID in the peer command is
used. If only the default PW ID is
configured, the default PW ID is used.
If no default PW ID is configured, you
must provide a PW ID in the peer
command.
You must specify the no-split-horizon
keyword to disable split horizon when
you configure an NPE to establish a
U-PW with a UPE.