Configuring The Management Vlan - Siemens RUGGEDCOM WIN5123 User Manual

RUGGEDCOM WIN
User Guide
Figure 78: IP Settings Screen
2. Configure the following parameter(s) as required:
Parameter
Current LAN IP Address
Configured LAN IP Address
Current LAN Mask
Configured LAN Mask
RF IP mode
RF IP Address
RF IP Subnet Mask
RF IP Default GW
3. Click Apply.
4. If you changed the value in the Configured LAN IP Address or Configured LAN Mask parameters, reboot the
device. For more information, refer to
NOTE
The DHCP client within the device does not release its IP address when the lease time is expired and it
does not update itself with the new IP address allocated by the server. Instead, it keeps the previous
IP address. Using a pre-provisioned IP address is preferable as a pre-provisioned IP address does not
require renewing. If not using a pre-provisioned IP, de-register the SS from the base station to get the
new IP address configured at the DHCP server.
Section 5.15

Configuring the Management VLAN

Management VLAN options include the VLAN number and the 802.1p priority value. Outgoing management
frames are tagged with the configured VLAN number and priority. Incoming management frames must be tagged
with the same values, or the SS drops the incoming frames.
Configuring the Management VLAN
Description
Displays the currently configured SS LAN IP address.
The LAN IP address, an IPv4 address.
Displays the currently configured LAN netmask.
The LAN mask, a dotted-decimal mask.
Synopsis: { Static, DHCP }
Displays the RF IP mode.
Displays the RF IP address.
Displays the RF IP subnet mask.
Displays the RF default gateway.
Section 4.5, "Rebooting the Device"
Setup and Configuration
.
Chapter 5
83