Vehicle Information - Bosch OBD 2220 INFO SCAN User Manual

The second "Test Results" screen example did detect
that the engine had started, and a KOER reading is
displayed.
The second "Test Results" screen example shows that
the KOEO voltage before an engine start was attempted
was 11.7V. Once the starter began cranking the engine,
a cranking voltage of 8V was measured. After the engine
started, a KOER voltage reading of 14.6V was measured.
• If the KOEO voltage is very low, this could be an
indication of a bad battery, or one that needs to be
charged.
• If the cranking voltage is a lot lower than the KOEO
voltage, than this is an indication of a worn starter.
• If the KOER voltage is not higher than the KOEO
voltage, than this indicates a bad or weak alternator.
7. After reviewing the test results, press
return to the Diagnostic Menu.
5.14

Vehicle Information

The Vehicle Information function allows the scan tool to
request the vehicle's VIN number, calibration ID(s) which
identifies software version in vehicle control module(s),
calibration verification numbers (CVN(s)) and in-use
performance tracking.
• Vehicle Information function applies to model year
2000 and newer OBDII compliant vehicles.
• The scan tool cannot verify if data is correct for
scanned vehicles.
• CVNs are calculated values required by OBDII regula-
tions.
• The CVN calculation may take several minutes.
• CVNs are reported to determine if emission-related
calibrations have been changed. Multiple CVNs may
be reported for a control module.
• In-use performance tracking, tracks performance of
key I/M Monitors.
From Diagnostic Menu:
1. Select Vehicle Information.
• Use the and
mation is highlighted.
• Press .
Diagnostic Menu
Record Data
View Freeze Data
Drive Cycle Monitor
O2 Monitor Tests
Diagnostic Monitor Tests
On-Board Systems
Charging System Monitor
Vehicle Information
Component Locator
Rd\Er
2. Select information to view from the menu.
Bosch Automotive Service Solutions Inc.
or to
keys until Vehicle Infor-
OBD 2220 Info Scan | User guide | 31 | en
• Use the and
tion is highlighted.
• Press .
Vehicle Information
VIN
CVN
CAL ID
IPT
Rd\Er
• If the selected menu item has data for more
than one module, a menu listing all modules
returning data for that menu item is shown.
3. View information supported by vehicle.
• Use the and
VIN (MOD $09)
1HGCM56866A018504
CVN (MOD $09)
00 5C 02 52
CAL ID (MOD $09)
37805-RAD-A590
keys until desired selec-
keys (if required).
580000 | REV. A | 04.2017