Timing Chain Cover Cleaning And Inspection; Timing Chain And Chain Tensioner Components - Suzuki Liana RH413 Service Manual

1D-19 Engine Mechanical:
4) Install water pump pulley.
5) Install P/S pump bracket (if equipped).
6) Install cylinder head cover referring to "Cylinder
Head Cover Removal and Installation".
7) Install oil pan referring to "Oil Pan and Oil Pump
Strainer Removal and Installation in Section 1E".
8) Install crankshaft pulley (1). Tighten bolt (2) to
specified torque. To lock crankshaft pulley, use
special tool with it as shown in the figure.
Special tool
(A): 09917–68221
Tightening torque
Crankshaft pulley bolt (a): 150 N·m (15.0 kgf-m,
108.5 lb-ft)

Timing Chain and Chain Tensioner Components

1. Crankshaft timing sprocket
2. Timing chain
: Apply engine oil.
3. Timing chain No.1 guide
: Apply engine oil to sliding surface.
9) Install engine assembly to vehicle referring to
"Engine Assembly Removal and Installation".

Timing Chain Cover Cleaning and Inspection

Clean
Clean sealing surface on timing chain cover, cylinder
block and cylinder head.
Remove oil, old sealant, and dust from sealing surface.
Inspection
Check oil seal lip for fault or other damage. If damage is
found, replace oil seal referring to "Timing Chain Cover
Removal and Installation".
4. Timing chain tensioner
: Apply engine oil to sliding surface.
5. Timing chain tensioner adjuster assembly
6. Chain tensioner adjuster mounting bolt
I2RH0B140056-01
S3RH0A1406021
S3RH0A1406025
I2RH0B140059-01
7. Chain tensioner mounting bolt
8. Chain guide mounting bolt
: Tightening torque