Table of Contents
Advertisement
Braking: 6
to start the engine or select the ignition
mode. The "remote controller outside"
warning may not be given at that time.
–The remote controller is outside the
vehicle but very close to a door.
–The remote controller is on the instru-
ment panel.
Parking Brake Lever
EXAMPLE
(2)
(3)
(1) To set
(2) To release
(3) To release
The parking brake lever is located between
the seats. To set the parking brake, hold
the brake pedal down and pull the parking
brake lever all the way up. To release the
parking brake, hold the brake pedal down,
pull up slightly on the parking brake lever,
push the button on the end of the lever with
your thumb, and lower the lever to its origi-
nal position.
For automatic transaxle vehicles, always
set the parking brake before moving the
gearshift lever to the "P" (PARK) position. If
you park on an incline and shift into "P"
before setting the parking brake, the
weight of the vehicle may make it difficult to
shift out of "P" when you are ready to drive
the vehicle.
When preparing to drive the vehicle, move
the gearshift lever out of the "P" position
before releasing the parking brake.
WARNING
• Never drive your vehicle with the
(1)
parking brake on: rear brake effec-
tiveness can be reduced from over-
heating,
brake
life
shortened, or permanent brake
damage may result.
• If the parking brake does not hold
the vehicle securely or does not
fully release, have your vehicle
54G039
inspected immediately by an autho-
rized MARUTI SUZUKI dealer.
WARNING
Always set the parking brake firmly
before leaving your vehicle or it may
move, causing injury or damage.
When parking, make sure the gear-
shift lever is in reverse or first gear.
Remember,
even
transaxle is in gear, you must set the
parking brake firmly.
OPERATING YOUR VEHICLE
WARNING
When
parking
extremely cold weather, the following
procedure should be used:
1) Set the parking brake firmly.
2) Manual transaxle - turn off the
engine, then shift into reverse or
first gear.
Auto Gear Shift - shift into reverse
or first gear and check the gear
position indicator in the instru-
ment cluster to make sure that the
transaxle is engaged in 1st or
may
be
reverse, then turn off the engine
completely.
Automatic transaxle - shift into
"P" (Park) and turn off the engine.
3) Check the parking brake firmly
again. Get out of the vehicle and
put chocks under the wheels.
4) Release the parking brake.
When you return to your vehicle,
you must remember to first set the
parking brake, then remove the
wheel chocks.
Parking Brake Reminder Buzzer
A buzzer sounds intermittently to remind
you to release the parking brake if you
though
the
start the vehicle without releasing the park-
ing brake. Make sure that the parking
brake is fully released and the brake sys-
tem warning light turns off.
the
vehicle
in
3-8
74LH0-74E
Advertisement
Table of Contents
