Table of Contents
Advertisement
Engine Coolant: 1, 2
For nickel spark plugs (traditional
type):
You should inspect spark plugs periodically
for carbon deposits. When carbon accu-
mulates on a spark plug, a strong spark
may not be produced. Remove carbon
deposits with a wire or pin and adjust the
spark plug gap.
To access the spark plugs:
1) Unclamp the air cleaner cover.
2) Remove the engine top cover.
3) If necessary, disconnect the coupler (1)
while pushing the release lever.
4) Remove the igniter bolts.5) Pull the
spark plug boots out.
NOTE:
When installation, make sure the wires,
couplers, sealing rubber of top cover and
washers, are correctly returned in place.
52KM122
NOTICE
• When disconnecting the spark plug
cables, pull on the boot, not on the
cable itself. Pulling on the cable
can damage it.
• When servicing the iridium/plati-
num spark plugs (slender center
electrode type plugs), do not touch
the center electrode, as it is easy to
damage.
INSPECTION AND MAINTENANCE
NOTICE
• When installing the spark plugs,
screw them in with your fingers to
avoid
stripping
the
Tighten with a torque wrench to
17.5 Nm (1.8 kg-m, 12.916 lb-ft). Do
not allow contaminants to enter the
engine through the spark plug
holes when the plugs are removed.
• Never use spark plugs with the
wrong thread size.
60G102
Spark plug gap "a"
1.0 mm +/- 0.05 mm
NOTICE
When replacing spark plugs, you
should use the brand and type speci-
fied for your vehicle. For the speci-
fied
spark
plugs,
refer
"SPECIFICATIONS" section at the
end of this book. If you wish to use a
brand of spark plug other than the
60G160S
specified
plugs,
consult
MARUTI SUZUKI dealer.
threads.
54G106
to
the
your
7-12
74LH0-74E
Advertisement
Table of Contents
