Table of Contents
Advertisement
NOTE:
The word "CENTER" is molded on the
buckle and latch plate of the center lap
belt. The buckles are designed so a latch
plate can not be inserted into the wrong
buckle.
Driver's Seat Belt Reminder
(if equipped)
EXAMPLE
74LHT0214
When the driver does not buckle his or her
seat belt, the driver's seat belt reminder
light in the instrument cluster will come on
or blink and a buzzer (if equipped) will
sound as a reminder to the driver to buckle
his or her seat belt. For more details, refer
to the explanation below.
If the driver's seat belt remains unbuckled
when the ignition switch is turned to the
"ON" position or the engine switch is
pressed to change the ignition mode to
"ON". The reminder works as follows:
1) The driver's seat belt reminder light will
come on.
2) After the vehicle's speed has reached
about 15 km/h, the driver's seat belt
reminder light will blink and a buzzer
(if equipped) will sound for about 95
seconds.
3) After step 2) has finished, the reminder
light will remain on until the driver's seat
belt is buckled.
If the driver has buckled his or her seat belt
and later unbuckles the seat belt, the
reminder system will be activated from
step 1) or step 2) according to the vehicle's
speed. When the vehicle's speed is below
about 15 km/h, the reminder will start from
step 1). When the vehicle's speed is above
about 15 km/h, the reminder will start from
step 2).
The reminder will be automatically can-
celed when the driver's seat belt is buckled
or the ignition switch is turned off, or the
engine switch is pressed to change the
ignition mode to "LOCK" (OFF).
WARNING
It is absolutely essential that the
driver and passengers wear their seat
belts at all times. Persons who are
not wearing seat belts have a much
greater risk of injury if an accident
occurs. Make a regular habit of buck-
ling your seat belt before putting the
key in the ignition.
BEFORE DRIVING
Shoulder Anchor Height Adjuster
(if equipped)
EXAMPLE
Sash guide
Adjust the shoulder anchor height so that
the shoulder belt rides on the center of the
outboard shoulder. To upward, slide the
anchor up by pushing through the Sash
guide. To downward, slide the anchor
down while pulling the lock knob out. After
adjustment, make sure that the anchor is
securely locked.
WARNING
Be sure that the shoulder belt is posi-
tioned on the center of the outside
shoulder. The belt should be away
from your face and neck, but not fall-
ing off your shoulder. Misadjustment
of the belt could reduce the effective-
ness of the safety belt in a crash.
74LH0-74E
64J198
2-32
Advertisement
Table of Contents
