2
If Section "Monitor" or [Section "Screen" > Monitor] line is not exist,
.
refer to the following examples to create the new line.
Set [Section "Screen" > SubSection "Display" > Modes] as
1024x768. If Modes line is not exist, create the new line.
Set [Section "Screen" > DefaultDepth] or [Section "Screen" >
SubSection "Display" > Depth] as 16 (24 when set 24 bit).
Example of Section "Monitor" settings:
Section "Monitor"
Identifier "Monitor0"
ModelName "LCD Panel 1024x768"
HorizSync 31.5 – 48.0
VertRefresh 26.0 – 65.0
Option "dpms"
EndSection
Example of Section "Screen" settings:
Section "Screen"
Identifier "Screen0"
Device "Videocard0"
Monitor "Monitor0"
DefaultDepth 16 <- "24" when set 24 bit
SubSection "Display" Viewport 0 0
Depth 16 <- "24" when set 24 bit
Modes "1024x768" EndSubSection
EndSection
Restart the X server to reflect the screen resolution.
Deactivation of LPAR
Execute [Shutdown of guest OS] when OS is operating normally.
Shutdown of Guest OS
Execute (Enter) the Shutdown command. When the Shutdown processing is
finished, the LPAR is deactivated.
Deactivation of LPAR
Operation of LPAR deactivation corresponds to turning off power of Server
Blade. Therefore take care enough for executing deactivation.
Especially, the deactivation during OS data access may destroy the data. So,
be sure to execute OS shutdown before LPAR deactivation.
1
Deactivate a LPAR from the LPAR manager screen.
.
On the [LPAR manager Menu] or [LPAR manager Menu or Logical Partition
Configuration] screen, press [F4] key for deactivation of LPAR.
5-64
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Setup of LPAR manager