Hitachi Compute Blade 500 Series User Manual page 342

Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
9-8
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
LP Loader recovery communication to SVP.
Communication failure is detected between LPAR manager and
Management module, therefore execute a recovery of
communication failure.
When this LP System Logs is taken at every LPAR manager boots,
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
LP Loader switched NIC port0 to port1.
Communication failure between LPAR manager and a
management module was not recovered by Port1(MGMT1),
therefore communications processing is carried out by
Port0(MGMT0).
When LP System Logs is taken at every LPAR manager boots,
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
LP-Loader updated LP Serial Number in OEM FRU.
FRU is updated when detecting N+M. (You can check that N+M
failover occurs from this message)
None
LP Loader updated VfcSeed.dat in management module.
This message is displayed when moving the server blade or
adding the server blade into the slot of the server-chassis which
operated LPAR manager in the past.
Synchronized the FRU information and the "Vfc seed information"
which is managed in management module.
None.
The value of MM Config Base is invalid. Change the value to
The value of MM Config Base is invalid. Change the value to 2 GB.
In the EFI setup menu, set MM Config Base to [2GB], and then
restart LPAR manager.
For details about the setup method, see the Hitachi Compute
Blade 500 Series EFI User's Guide.
This LP F/W is not supported for this blade(Compute Blade
Please install another LP F/W supported for this blade.
XXXX : Server Blade Model
This LPAR manager firmware is not supported for this server
blade.
Messages
2GB.
XXXXXX).