Dante Audio Network Settings - Yamaha CL5 Reference Manual

NETWORK window
1
2
1
IP ADDRESS
Specifies an address that identifies an individual device on the Internet or LAN network.
2
GATEWAY ADDRESS
Specifies an address that identifies a device (gateway) that converts data between
different media or protocols to allow communication within the network.
3
SUBNET MASK
Within the IP address used in the network, this defines the bits that are used for the
network address that distinguishes the network.
4
MAC ADDRESS
Indicates the MAC (Machine Access Control) address, which identifies a host in a
network. This address is for display only, and cannot be
NOTE
The NETWORK connector on the CL series console transmits data via either 100BASE-TX
(transmission speed: maximum 100 Mbps) or 10BASE-T (transmission speed: max 10 Mbps).

Dante audio network settings

You will use the CL series console to make Dante audio network settings for the console itself
and the I/O devices connected to the Dante connector of the CL series console. This section
explains how to make Dante audio network settings.
STEP
1. In the Function Access Area, press the SETUP button to access the SETUP screen.
2. In the DANTE field at the center of the screen, press the DANTE SETUP button to
open the DANTE SETUP window.
3. Press the SETUP tab in the lower part of the DANTE SETUP window.
3
4
DANTE SETUP window (SETUP page)
2
edited.
4
8
9
226
SETUP screen
1 STATUS indicators
Show the operating status of the CL series console and the Dante network.
2
CONSOLE ID select buttons
Set the IDs for the CL series consoles.
If five or more CL units are connected to a network, and you plan not to assign IDs to
some of the units, press the OFF button of each of those units to turn off the ID.
3
SECONDARY PORT select buttons
Specify how the Dante audio network is configured.
DANTE SETUP window
1
3
5
6
7
Reference Manual
Setup