Panasonic KX-NS1000 Pc Programming Manual page 115

Test Type
CS-INF loop back diagnosis*
Super frame synchronization
diagnosis*
Caller ID card loop back diagnosis
To perform a card test
1.
Click on the Status cell of the card to be tested, and set it to "OUS".
2.
Click on the cell showing the card type.
A new window will be displayed.
3.
Select the Card Test option, and then click Execute.
The error report will be displayed. When all tests are completed, the words "Test End!" will be shown on
the last line of the output.
4.
Select an option:
•
Click Capture if you want to save the displayed information as a CSV file.
1.
Specify a save destination and file name.
2.
Click Save.
•
Click Cancel to return to the Diagnosis screen.
Network Loopback Test
Performs a remote loopback test on the PRI23 card.
Note
To perform this test, it is necessary to set
Configuration—[1-1] Configuration—Slot—Port Property - PRI Port—CO Setting to "Enable".
To perform a network loopback test
1.
Select Point1 or Point2 depending on the type of loopback test you want to perform.
The available selections may vary depending on the hardware version of the card.
2.
Click Apply.
Preparation for the test is complete. The test will start automatically.
3.
After the test is complete, select Release and click Apply.
4.
Click Cancel to return to the Test Menu screen.
Pair Port Test
Tests the combination of an extension port and CO line port to ensure that communication with the CO line
port can be carried out successfully. Only cards installed in legacy gateway KX-TDE/KX-TDA PBXs can be
tested.
The pair port test can be carried out using one LCOT or ELCOT card and one DHLC8, SLC8, SLC16,
MSLC16, ESLC16, EMSLC16, CSLC16, or ECSLC24 card.
Note
•
Cards installed in KX-NS1000 PBXs and legacy gateway KX-NCP PBXs cannot be tested using this
utility.
•
The cards to be used for testing must be installed in the same legacy gateway PBX.
Document Version 2016-03
CSIF
CSIF
KX-NS1000 PBXs:
LCOT2
Legacy Gateways:
LCOT, ELCOT
Loopback Test started by Network in 9.27 PBX
7.1.1 Utility—Diagnosis—Card Diagnosis
Available Cards
PC Programming Manual 115