Toshiba Q9 Installation And Operation Manual page 197

Table 4. (Continued) Discrete Input Terminal Assignment Selections and Descriptions.
Sel. No.
NO NC
UP/DOWN Frequency (UP) — Increases the speed of the motor for the duration of activation until reaching the
88 89
Upper-Limit setting or increases the speed of the motor in steps (see
UP/DOWN Frequency (DOWN) — Decreases the speed of the motor for the duration of activation until reaching the
90 91
Lower-Limit setting or decreases the speed of the motor in steps (see
UP/DOWN Frequency (CLEAR) — While operating in the Up/Down Frequency speed control mode this terminal
92 93 initiates a 0 Hz output command. If operating with an activated UP/DOWN Frequency (UP or DOWN) terminal, the
output goes to the Lower-Limit (F013) setting.
Forward/Reverse — This setting operates in conjunction with another terminal being set to the Run/Stop function.
98 99 When configured to Run (Run/Stop to CC), the make or break of this connection to CC changes the direction of the
motor.
100 101 Run/Stop — This terminal enables the motor to run when activated and disables the motor when deactivated.
Line Bypass — Initiates the ASD-to-Commercial Power switching function.
102 103
See parameter F354
Frequency Priority — Toggles frequency control to and from the settings of
104 105
deactivation.
106 107 V/I Terminal Priority — Assigns Speed control to the V/I Terminal and overrides the
108 109 Terminal Priority — Assigns Command control to the Terminal Board and overrides the
110 111 Edit Enable — Allows for the override of the lockout parameter setting (F700) allowing for parameter editing.
Fast Deceleration — Using dynamic braking (if enabled and supported), stops the motor at the fastest rate allowed
122 123
by the load.
124 125 Pre-Excitation — Applies an excitation current to the motor (holds shaft stationary) for the duration of the activation.
Note: NO/NC = Normally Open/Normally Closed.
Q9 ASD Installation and Operation Manual
Terminal Selection Descriptions
for more information on this feature.
F264 for more information on this feature).
F264 for more information on this feature).
F004 and F207 with each activation/
F004 setting.
F003 setting.
187