Displayed Contents - Mitsubishi Electric GOT2000 Series User Manual

4.6 How to Operate Ladder Monitor Screen
On the Ladder monitor screen, the GOT displays the read sequence program.
The following describes how to operate the Ladder monitor screen.
4.6.1

Displayed contents

The following describes the configuration of the Ladder monitor screen, menus and key functions on the screen.
8)
No. Item
1) PLC name
2) Target controller
3) Program name
4) Number of steps
5) Keys
6)
Ladder display area
7) Current device value display area
8) Message display area
1)
Displays the label set in the PLC name setting for the target PLC CPU.
Displays the CH No., network No., station No., and CPU No of the target PLC CPU as shown
below.
• CH No. network No.-station No./CPU No.
Displays the file name of the displayed sequence program.
Displays the number of steps for the displayed sequence program.
Keys operations for the Ladder monitor screen shown in 4.6.2. (Touch input)
Displays the read sequence program.
By touching a device, it is selected and surrounded with a green frame.
The following shows the conductive status
Non-conductive status
Contact
Coil
*2
*1
Instruction
When contacts, coils, and outputs are the selection status, touching the area displays the
device search window.
➠
4.8.1 Device/Contact/Coil search
Displaying the first step number
When the Ladder registration monitor window is opened, the first step number of registerable
ladder blocks is highlighted. Touching the area registers the specified ladder block in the
window. (For the Factor mode, it is not registered even if it is touched.)
➠
4.6.3 ■3. Display menu (1) Ladder registration monitor window
Displays the current value of the displayed word device.
Displays error messages and others.
4) 5) 6) 5)
2) 3)
Description
Conductive status
4.6 How to Operate Ladder Monitor Screen
5)
7)
5)
4 - 27
4